Many of our new freeride and downhill boards use a rocker concave.
It gives you:
- A slightly lower ride - which means lower centre of gravity with more board control, especially for sliding
- A dead flex thanks to the pre tensioning of the veneers in the press. This translates to less board chatter going sideways
- With some shapes, it allows us to press sick pockets for your feet. By varying the position of the blank in the mould and altering the shape, we can vary the concave at different points of the deck to suit a specific purpose. The Antuna speedboard has a steeper concave at the rear "hips" to lock your back feet in but still allow front foot movement, whilst the Symbian freeride deck has identical concave for your front and back feet to give maximum grip.
- Slightly more turn from your trucks as the truck mounts are slightly angled
- Enhanced board feel
The Symbian (above), Legend and Machine all have small kicks in addition to the rocker, opening up a whole world of shuvits, flips, ollies, airs, anything you can do on a normal skateboard... the lines are getting blurry!
For flexy boards, we use a Cambered profile. We've used camber in various longboards for over a decade - there's no better way to produce a lively flex from wood.
It gives you:
- A springy flex, as the veneers are "pre tensioned" against your weight in the press, the deck "springs" out of carves and gives a super-nice carving feeling. If you're into surfing and snowboarding - you will like it!
- A slightly higher ride height which equates to more lean and a better turn on your trucks.
If you want to carve it up... Camber is the way to go.